For the purpose of this guide, we’re going to do a detailed walk-through of setting up and using the very popular Nvidia EWBF Miner. If you have AMD cards, mining Ethereum is usually your most profitable option.
Check out Mining Pool Hub and the MultiPoolMiner they link to on their site. You can do CPU mining with it. It will benchmark several different miner applications and automatically switch to mining the most profitable coin. You can also select to be paid BTC/ETH/etc.
Some of the above specialize for AMD GPUs, whereas other are tailored to Nvidia GPUs. However, you’ll find that the Claymore Miner works just fine for both, so the choice is ultimately a matter of preference.
Following the startup information. we can see we are getting block information from the pool and that our graphics card(s) are detected and being assigned new work. After a little bit you shoudl start seeing shares accepted messages indicating your GPU has found a solution, submitted it the the pool and it was accepted.
As you can see our current Hashrate is showing as 506.7 H/s, which is equivalent to the Sol/s reading on the miner. The avergae hashrate is showing as 494.6 and is the effective rate for the past 24 hours. I should point out that this rate is slightly lower than the average mainly as I shut this miner down a few times in the course of writing this guide. The final part are the valid and invalid shares. Obviously you want as near as 100% valid and 0% invalid as possible, but don’t be too concerned if your see 1 0r 2% in the invalid column on occasion.
Finally at the bottom we have the per worker statistics. If you have only one worker all these fields will show the same statistics, but this area breaks out the data for individual workers, where everything above was an aggregate of all your workers.
Two minus signs indicate variables or settings that will be supplied to the miner when it starts. Whatever directly follows a minus sign and setting is the value for the mining software to use. Let’s go through each in this file.
Possible with Nicehash or Minergate. Nicehash is good to use for easy setup, but the hash rate is around 30% less than if you set up your own mining software with Claymore or EWBF. We will therefore focus on GPU mining for this guide.
The answer? Difficulty. By automatically adjusting the computational difficulty of solving a block, the Zcash blockchain is able to maintain 2.5-minute intervals. You’ll notice that difficulty closely tracks hashrate, and it, too, has seen exponential growth this year:
For a solid budget card, the Nvidia 1060 with 6 GB of RAM is recommended (when in stock and not ridiculously overpriced due to the card shortages we’ve been seeing in summer 2017). This GPU will beat the AMD 480s when it comes to mining Zcash!
Cryptocurrency markets are volatile and are rife with manipulation. Zcash is a relatively medium sized cryptocurrency currently valued at around $150M USD (at $104 USD per ZEC.) As points of comparison, Monero’s market cap is about $500M at the time of this writing and larger players like Ethereum and Bitcoin are well over $10B USD each. With such a small market cap, Zcash is particularly susceptible to market fluctuations.
All content on Blockonomi.com is provided solely for informational purposes, and is not an offer to buy or sell or a solicitation of an offer to buy or sell any security, product, service or investment. The opinions expressed in this Site do not constitute investment advice and independent financial advice should be sought where appropriate.
I think I’m ready to start building a rig operating system from a stock OS. I’ll be using lubuntu (my pers fav). MIning rigs make the best home computers I have my smallest rig ( 5 x 1070 Founder edition) in my living room. I hope I get everything running smoothly so I can go ham on packages and running nodes.
It does mine but there is no way to get paid and you need to put your wallet address in some other website,the app crashes and suddenly stops constantly, it needs an update to fix all those software errors,is really bad design it should pay immediately after is done hashing and it should have a place to put your wallet so it sends the coins to the wallet directly and have no issues, very hard to get support, it seems to be working and hashing but just can’t get it to pay or no support, i don’t recommend it seems like a gimmicky lie
Since cryptocurrencies have risen exponentially in the past few months people want in. of the best ways to make money with currencies like Ethereum and Bitcoin is to ‘mine’ them. When you mine a cryptocurrency you are running a program on your computer to use your computers computing power on the network. Whenever your computer solves a piece of the puzzle, a block in the blockchain, your miner is rewarded. There are two main ways to mine: